Renovation and Electrical Installation for Oranjemund State Hospital

• Country: Namibia
• Summary: Renovation and Electrical Installation for Oranjemund State Hospital
• NAT Ref No: 67825148
• Deadline: 01 Jul 2022
• Financier: Self Financed
• Purchaser Ownership: Government
• Tender Value: Refer Document
• Notice Type: Tender
• Document Ref. No.:
• Purchaser's Detail:
  Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details.

  Login to see details
• Description:
• Quotation are invited for Renovation and Electrical Installation for Oranjemund State Hospital- Kharas Region. Item code Description Qty UOM 1. Taking down and removing ceilings, etc. Soft board or gypsum board ceilings in isolated panels 7 2m2 Each 2. Taking out and removing doors, windows, frames, etc.(alterations to openings and /or building up openings where applicable Timber single or double door and timber door frame exceeding 2.5m2 and not exceeding 5m2in area 2.0 each 3. Taking out and removing taps and mixtures Sink or bath mixture 2.0 each 4. Brickwork in 7MPa cement bricks in class 11 mortar in building up openings, including cutting toothings and bonding new to existing Half brick walls 1.94 m2 Each 5. Breaking out for and forming openings through brick walls for new door frames and windows including making good plaster on From opening through one brick wall pressed steel door frame not exceeding 2.5m2 and make good plaster around both sides 1.0 each 6. One coat internal compo plaster steel trowelled smooth Hack of internal plaster in small isolated patches and replastcr to match existing 5.0 m2 Each 7. Rc-fixing of existing sanitary fittings in new position(removal of sanitary fittings elsewhere measured Stainless steel single or double bowl sink and drainer unit 1.0 Each 8. Clean down and prepare and one coat Acrylic PVA Paint On internal smooth plastered walls and columns 5.0 m2 Each 9. Excavation in earth not exceeding lm deep Trenches and holes 4.0 m3 Each 10. Earth filling obtained from excavations and\or prescribed stock piles on site compacted to 93%Mod AASHTO density Backfilling to trenches, holes, etc. 2.5 m3 Each 11. 20MPa\19mm concrete Surface beds, aprons, pavings, ramps, etc. cast in panels 4.0 m5 Each 12. Brickwork of 7MPa cement bricks in class II mortar Half brick wall 27.08 m2 Each One brick wall 3.0 m2 m2 13. Wrot Mcranti 69x102mm Rebated door frame to suit 40mm door size 813x2032mm high countersunk plugged, screwed and pelleted to wall 13.0 each 14. 44mm Solid laminated flush doors with hardwood veneer on both sides and concealed edge strips Door size 813 x 2032mm high 14.0 each 15. VVrot hardwood sliding doors with frames with a linseed oil-based transit stabilizing sealer and a seven year guarantee fixed in Sliding door with frame type SSDP 1.8 size 1800x2140mm high (2.083m2 glass area) 1. each 16. Wrot laminated shelving 22mm Shelving 305mm wide fixed to bearers (bearers 50.0m elsewhere measured) 17. Cupboard and drawer locks Euro profile single cylinder lock with Euro profile lock case and brass forend 10.0 each 18. Door closes and floor springs work ‘Union Gower- lever furniture (pair) with bathroom/wc indicator 12.0 Sets 19. Vertical louvred sun drapes compromising natural anodised aluminium top rail, 120mm wide type F13 colour group 5 louvre White powder coated single aluminium oval regular duty curtain track with accessories complete fixed to timber pelmets 200.0m Each 20. Natural anodised aluminium top-hung projected-out windows glazed with and including 4mm clear float g|ass Extra for glazing with 4mm obscure glass in lieu of 4mm clear float glass (measured across the full window area) 7.2 m2 Each 21. Walls Take delivery of, transport to the site, store, protect and lay ceramic tiles fixed with and including adhesive to plastered 25.0 m2 Each 22. Take delivery of, transport to the site, store protect and lay mazita or natural stone floor tiles of differing sizes fixed and Floor patterns 20.0 m2 Each 23. Take delivery of, transport to the site, store, protect and lay mazita or natural stone floor tiles of differing sizes fixed with and Skirting 100mm high 10.0m Each 24. White vitreous china or glazed fireclay Double end bowl inset sink and drainer unit size 1200x500mm 1.0 each 25. Polyethylene, duranite, etc. Basin size 560x400mm with two tap holes to walls with and including semi-concealed cast iron brackets 32.0 each 26. Porcelain enamelled steel baths 9 Litre high-level duranite w.c cistern complete with flusing mechanism, flush lever and flush pipe 5.0 each 27. Chromium plated brass Bath size 1700x700mm with adjustable feet, anti-slip finish and chrome handles 2.0 each 28. Vulcathene 40mm Bath or sink waste union with vulcanite plug and chromium plated chain and stay 40.0 each 29. Chromium plated brass 40mm Bottle trap including tailpipe and wall flanged 40.0 each 30. Water meters of semi-positive rotary piston type with flanged connections 20mm Vacuum breaker 4.0 each 31. Water meters of semi-positive rotatory piston type with flanked connections 20mm Expansion relief valve (200kPa) 4.0 each 20mm ‘Masterflo- 200KPa pressure reducing valve with strainer and integral no-retum valve 4.0 each 32. Chromium plated brass medical taps and mixers 15mm Angel regulating valve only 80.0 each 15mm Angle regulating valve with stainless steel braided connector pipe 315mm girth with chromium plated connections 80.0 each 15mm Toilet bib tap 10.0 each 15mm Single tap hole sink mixer with swivel outlet and angle regulating valves 1.0 each 20mm Wall Type bath mixer 2.0 each 15mm Shower rose 85mm diameter 5.0 each 33. Special valves and fittings 15mm Elbow action wall type medical mixer with swivel outlet 32.0 each 34. Water heaters 200 litre Geyser for horizontal or vertical installation 4.0 each 35. Extra over HDPE pipes for the following compression fittings 25mm Pipes laid in ground trenches 100m Each 36. Class 9 uPVC water pipes and Fittings including all straight joints and connectors laid in ground in tenches not less 600mm 25mm fittings 20.0 each 37. Fire appliances work 40mm Pipes laid in ground in trench 60.0m Each 110mm Pipes laid in ground in trench 35.0m Each 38. Class 12 uPVC water pipes and fittings including all straight joints and connectors laid in ground in tenches not less 600mm 40mm Socket adapter coupling 20.0 each 110mm Socket adapter coupling 8.0 each 40mm Straight reducing piece 20.0 each 110mm Straight reducing piece 8.0 each 40mm Elbows 20.0 each 110mm Elbow 8.0 each 40mm Equal tee 20.00 each 39. Extra over class 0 copper pipes for brass capillary fittings 15mm Pipe fixed or chased into walls 40.0m Each 22mm Pipe fixed or chased into walls 40.00m Each 40. Galvanised mild steel medium grade pipes including all straight joints and connectors 15mm Fittings (elbows, tecs, reducing tecs, adaptor couplings, etc.) 15.0 each 22mm Fittings (elbows, tees, reducing tees, adaptor couplings, etc.) 20.0 each 41. Extra over galvanised steel pipes for steel fittings 20mm Pipe fixed or chased into walls 12.0m Each 42. PEX/AL/PEX Multilayer polygon pipes or other equal and approved 20mm Fittings (elbows, ices, reducing tees, adaptor couplings, etc.) 15.0 each 43. Sundries to water supplies work ‘Everyway- hose reel complete with 30m rubber hose, chromium plated stopcock, shut-off nozzle and wall bracket 2.0 each 44. Underground twin-wall uPVC structured wall pipes laid in ground, including excavations, backfilling, etc. and all straight joints 110mm Access bend with vent horn 5.0 each 45. UPVC Gulleys with gullley head and grating encased in concrete 110mm Rodding eye 3.0 each 46. Inspection chambers 110mm Gulley P-trap not exceeding Im deep 3.0 each 47. White powder coated aluminium Flagpole 7500mm high overall comprising: 76mm external diameter x 2.8mm thick lower post 4000mm long four times holed 2.0 each 48. Total Value of building items 49. Escalation at 0.12 50. Sub Total: 51. District Allowance 8% 52. Sub Total: 53. Preliminaries Allowance 8% A B C D Item code Description Qty UOM Unit Price NS (Excl VAT Total price NS Excl. VAT) 1. Plasticised polyvinyl chloride (UPVC) sleeve piping including short lengths and jointing, laid in trench (trench backfilling) (Electrical Installation work) 32mm Diameter x 300mm long complete with connectors at both ends 10.0 No Initial: 15 2. Sundries (work) 110mm Diameter long radius bend 10.0 No 3. Silicone insulated wires asbestos 4mm2 20,0m 4. Underground cable PVC SWA PVC installed 4mm2 10.0m 5. Metal Cable terminations 4mm2 Surfix cable 2 core + Earth 30.0m 6. Cover only double outlet lOOmni x 100mm Double outlet 100 x 100mm complete with cover 8.0 No 7. Single pole As above, but surface mounted including enclosure 4.0 No 15-25 Amp 1.0 No 8. Double pole 30-40 Amp 4.0 No 9. Total Value of Building Items: 10. Value of Scheduled Items: 11. Escalation at 0.12 12. Sub Total: 14. District Allowance 8% 16. Preliminary Allow ance 8% For enquiries, please contact the following people: 1. Technical enquiries: Mr. N. Hilukilwa- Tel: 061- 2032744 2. Administrative enquiries: Ms. M.P. Epafras- Tel: 061- 2032255 Sealing and Marking of Quotations Quotations should be sealed in a single envelope, clearly marked with the Procurement Reference Number, addressed to the Ministry, with the Bidder's name and contact information at the back of the envelope. Submission of Quotations Quotations should be deposited in the Quotation/Bid Box located at The Ministry of Health and Social Services - Finance and Procurement building, Procurement Management Unit (Tender Office), Harvey Street, Windhoek-West, not later than 01 July 2022, Time: 11H00. Opening of Quotations Quotations will be opened internally by the Ministry immediately after the closing time referred to in instruction 7 above. A record of the Quotation Opening stating the name of the bidders, the amount quoted, will be posted on the website of the Ministry and available to any bidder on request within th
• Documents:

 Tender Notice